• Only connect the unit to a power socket with earthing contact
(PE – protective earth)!
• The power supply plug serves as a safe disconnecting device
from the line and must always be easily accessible.
• Place the instrument on an even surface on a pad made of
non-inflammable material.
• Do not stay in the area below the unit.
• Make sure you read and understand all instructions and
safety precautions listed in this manual before installing or
operating your unit.
• Never operate the unit without bath fluid in the bath.
• Do not drain the bath fluid while it is hot or cold!
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
• Use suitable connecting tubing.
• Make sure that the tubing is securely attached.
• Avoid sharp bends in the tubing, and maintain a sufficient
distance from surrounding walls.
• Regularly check the tubing for material defects (e.g., for
cracks).
• Never operate damaged or leaking equipment.
• Always turn off the unit and disconnect the mains cable from
the power source before performing any service or
maintenance procedures, or before moving the unit.
• Always turn off the unit and disconnect the mains cable from
the power source before cleaning the unit.
• Always empty the bath before moving the unit.
• Transport the unit with care.
• Sudden drops may cause damage in the interior of the unit.
• Observe all warning labels.
• Never remove warning labels.
• Never operate equipment with damaged mains power cables.
• Repairs are to be carried out only by qualified service
To Next Page
Loading...
