Julabo FC600 - Command List and Status Messages

Recirculating coolers
33
9.2. List of commands
Command Parameter Response of recirculating cooler
version no Number of software version
status no Status message (see below)
out_mode_04
out_mode_04
in_mode_04
0
1
no
Set control mode via PC
Set control mode via programmer input (O)
Ask for actual control mode
out_mode_05
out_mode_05
in_mode_05
0
1
no
Stop the recirculating cooler = rOFF
Start the recirculating cooler
Ask for actual condition (Start/Stop)
out_sp_00
in_sp_00
xx.x
no
Set working temperature value
Ask for working temperature value
in_sp_01 no Ask for high temperature value
in_sp_02 no Ask for low temperature value
out_sp_03
in_sp_03
xxx
no
Set control ratio for feed/return flow temperature
Ask for actual control ratio
in_pv_00 no Ask for actual feed temperature
in_pv_01 no Ask for actual temperature of external sensor
in_pv_02 no Ask for actual heater capacity
in_pv_03 no Ask for actual return temperature
in_pv_04 no Ask for actual safety temperature
out_par_06
in_par_06
x.x
x.x
Control parameter Xp of the internal controller
out = set; in = ask
out_par_07
in_par_07
xx.xx
xx.xx
Control parameter Tn of the internal controller
out = set; in = ask
out_par_08
in_par_08
xx.xx
xx.xx
Control parameter Tv of the internal controller
out = set; in = ask