Need help?Do you have a question about the JUMO Quantrol LC300 and is the answer not in the manual?
General| Inputs | 1 or 2 |
|---|---|
| Mounting | Panel mounting |
| Operating Temperature | 0 to 55 °C |
| Storage Temperature | -20 to 70 °C |
| Weight | Approx. 200 g |
| Display | LCD |
| Input Types | Thermocouples, RTD |
| Output Types | Relay |
| Control Algorithm | ON/OFF |
| Communication | RS485 (optional) |
| Protection Class | IP65 (front) |
| Output Channels | 1 or 2 |
| Power Supply | AC 110 to 240 V |
| Input Channels | 1 or 2 |
Provides essential safety guidelines and explains warning signs for safe operation.
Provides step-by-step instructions for mounting the LC100, LC200, and LC300 controllers into a panel.
Shows the terminal assignments for LC100, LC200, and LC300 models, including USB interface.
Covers basic device operation, including display elements and modes.
Introduces the configuration level where device settings are managed.
Details the configuration options for analog inputs, including probe types and standard signals.
Covers controller configuration, including type, action, output modes, and setpoint limits.
Explains the setup of limit value monitoring functions, alarm types, and switching differentials.
Covers the configuration of binary and analog outputs, including their functions and signal types.
Covers the advanced controller parameter settings like proportional band, derivative time, and reset time.
Describes the self-optimization process for tuning PID or PI controllers.
Lists common error displays, their causes, and recommended fault remedies.
To Next Page