SV- SERVER / SV-SERVER-INT 105 / 187
8.4.4 Configuring KNX functions
Successful commissioning of the KNX system and definition of the KNX-IP Gateway in SV-
Control are required to be able to use KNX functions.
Access as Administrator or User
The "User" and the "Administrator" have different access rights to KNX functions within the
"Functions" column.
Edit the names of the KNX functions
Edit the icons of the KNX functions
Assign new existing KNX functions to new areas
Remove existing KNX functions from new areas
Edit the group address of the KNX functions
Permanently delete existing KNX functions
Figure 84: Access rights to KNX functions
Each KNX function can be described by a specific function type and summarises suitable
ETS group addresses.
The following function types are available to the Administrator:
Brightness value
feedback
Brightness value
feedback
To Next Page
Loading...
Need help?
General
