Jung Smart Visu Server Series - Page 116

SV- SERVER / SV-SERVER-INT 115 / 187
Dimmer/Switch:
The "Dimmer" function (1) is used for simple dimming of dimmer actuators. A "Switching"
(2) and / or "Brightness value" (4) group address can be configured for switching or writing
a new brightness value. In the same way, to read the feedback, it is possible to configured
the group addresses "Switching feedback" (3) and "Brightness value feedback" (5).
In addition, the current status of a selectable group address can be polled by defining an
initialisation address (6) on starting the system.
Figure 89: Parameters of the "Dimmer/Switch" function
The function possesses the following individualisation options within the icon library (7).
KNX function
Selection of the icon library in SV-Control
Operating and display element in SV-Home
Dimmer
Table 38: Display of the "Dimmer" function
1
2
3
4
5
7
6