junger Accent1 - Technical Specifications; Digital Signal Processing; Digital Inputs and Outputs; Analog Inputs and Outputs

8. TECHNICAL SPECIFICATIONS
T ECHNICAL SPECIFICATIONS 8
DIGITAL SIGNAL PROCESSING 8.1
sampling rate 44.1 kHz ... 96 kHz
audio data format 24-bit (AES/EBU)
dither TPDF type, 16bit, 20bit
channel status bits transparent or conversion to consumer
or professional
sample rate converter asynchronous 44.1 kHz ... 96 kHz,
24bit, THD+N: -110dB
processing delay 2ms (44.1/48kHz), 1ms (88.2/96kHz)
DIGITAL INPUTS AND OUTPUTS 8.2
AES/EBU
connector XLR, 5Vpp / 110 Ohm, balanced
BNC, 0.5Vpp / 75 Ohm unbalanced
input format AES professional, AES consumer
output format same as input
SYNC
WCLK in BNC, 1kOhm, unbal., TTL-level
WCLK out BNC, unbal., HCMOS
ANALOG INPUTS AND OUTPUTS 8.3
INPUT
A/D-converter 24bit, oversampling, 44.1...96kHz
dynamic range 116dB (RMS), 118dB(A)
input level +12...+24dBu @ 0dBFS
THD -100dB @ -1dBFS
CMRR >110dB @ 50Hz, >90dB @ 20kHz
impedance 10kOhm, floating balanced
OUTPUT
D/A-converter 24bit, oversampling, 44.1...96kHz
dynamic range 117dB (RMS), 120dB(A)
output level +12...+28dBu @ 0dBFS
THD 0.0012% @ +15dBu
impedance 30Ohm, floating balanced
Operation manual accent2, chapter 8 -technical specifications- page 8-1