To Next Page

To Previous Page

E 9

0803.GB

Switching on the truck

When the truck is parked, the running surface of the tyres will flatten. The flattening

will disappear after a short operating time of the truck.

– Step on to the standing platform.

– Switch on the master switch (6) by turning it in the direction of the arrow (if neces-

sary, all master switches).

– Insert the key in the key switch (9) and turn the key clockwise towards the “I” posi-

tion until reaching the stop.

– Check the horn (10) for correct functioning.

– Check the deadman key (16) / (17 (2nd operating console)) and the controller (1)

for correct functioning (refer to section 4.2).

The truck is now ready for operation. The steering system assumes the position for

driving straight ahead.

The information and service display (4) briefly shows the truck identification and then

indicates the current steering position of the drive wheel (straight ahead), the current

battery capacity and the operating hours.

– Check the brakes for correct functioning (refer to section 4.2).

E 9