Jungheinrich ECP 100-3 User Manual

0201.GB
C 2
3 Moving the truck with the drive unit inoperative
f
This operating mode is not permitted when negotiating inclines and gradients.
A
Malfunction of the electrical system or battery failure causes automatic braking of the
truck.
If the truck has to be moved after a failure has rendered it immobile, proceed as fol-
lows:
– Set the master switch to position “OFF”.
– Set the key switch to position “OFF” (“0”) and remove the key.
– Ensure that the truck cannot accidentally move.
– Open the front hood, remove it and set it aside (refer to chapter F, section 6.3).
– Slacken the lock nuts (4) and tighten the screws (3).
The brake has now been released and the truck can be moved.
3
4
5
7
7
6
0201.GB
C 2
3 Moving the truck with the drive unit inoperative
f
This operating mode is not permitted when negotiating inclines and gradients.
A
Malfunction of the electrical system or battery failure causes automatic braking of the
truck.
If the truck has to be moved after a failure has rendered it immobile, proceed as fol-
lows:
– Set the master switch to position “OFF”.
– Set the key switch to position “OFF” (“0”) and remove the key.
– Ensure that the truck cannot accidentally move.
– Open the front hood, remove it and set it aside (refer to chapter F, section 6.3).
– Slacken the lock nuts (4) and tighten the screws (3).
The brake has now been released and the truck can be moved.
3
4
5
7
7
6

Jungheinrich ECP 100-3 Specifications

General

Brand	Jungheinrich
Model	ECP 100-3
Category	Forklifts
Language	English