Jungheinrich ECP 100-3 User Manual

C 3
0201.GB
To steer the wheels mechanically (e.g. in narrow aisles), proceed as follows:
m
The truck may only be commissioned by authorised manufacturer’s service after wor-
king on the steering drive.
– Loosen the screws (5) on the steering drive and carefully remove the cover (6).
m
Make sure that the toothed shaft (at the end of the shaft (7)) is not damaged.
– Place an appropriate tool (e.g. an SW8 open-end wrench) onto the chamfered part
of the shaft (7).
– Turn the shaft (7) until the wheel is in the desired steering position.
The truck can now be moved in the desired direction.
m
No not remount cover (6) - inform manufacturer’s service.
f
After arriving at the destination, ensure that the brake is put back to its initial state.
The truck must on no account be parked with the brake in the released state.
– Loosen the screws (3) by approx. 1 cm and lock them by tightening the lock nuts
(4).
The brake is now applied again.
C 3
0201.GB
To steer the wheels mechanically (e.g. in narrow aisles), proceed as follows:
m
The truck may only be commissioned by authorised manufacturer’s service after wor-
king on the steering drive.
– Loosen the screws (5) on the steering drive and carefully remove the cover (6).
m
Make sure that the toothed shaft (at the end of the shaft (7)) is not damaged.
– Place an appropriate tool (e.g. an SW8 open-end wrench) onto the chamfered part
of the shaft (7).
– Turn the shaft (7) until the wheel is in the desired steering position.
The truck can now be moved in the desired direction.
m
No not remount cover (6) - inform manufacturer’s service.
f
After arriving at the destination, ensure that the brake is put back to its initial state.
The truck must on no account be parked with the brake in the released state.
– Loosen the screws (3) by approx. 1 cm and lock them by tightening the lock nuts
(4).
The brake is now applied again.

Jungheinrich ECP 100-3 Specifications

General

Brand	Jungheinrich
Model	ECP 100-3
Category	Forklifts
Language	English