Activating the brake
Procedure
• Use wedges to prevent the truck from moving.
• Remove the two M5x16 screws (69) from the brake (70).
CAUTION!
Open covers can cause injury and accidents
u
The covers (battery cover, side panels, drive compartment cover etc.) must be
closed during operation.
• Fit the right-hand drive panel (68).
• Fit the front panel (67).
The brake has been reactivated. The brake is now be applied without current.
WARNING!
Only return the truck to service when you have identified and rectified the fault.
100
04.19 en-GB
To Next Page
Loading...
Need help?
General
