5.2 Load cannot be lifted
Possible cause Actions
Truck not operational Carry out all actions listed under "Truck
does not start"
Hydraulic oil level too low Check the hydraulic oil level, see page 175
Battery discharge monitor has
switched off
Charge the battery, see page 45
Faulty fuse Check the fuses, see page 179
Excessive load Observe the maximum capacity, see data
plate
"Raise load handler" button/"Lower
load handler" button not in home
position when truck switched on (for
CanDis (o) or the display unit (2-inch
display) (o), event message E-2951
appears)
Do not actuate the button
Travel switch not in home position
when truck switched on (for CanDis
(o) or the display unit (2-inch display)
(o), event message E-1901 appears)
Do not actuate the travel switch
Collision safety switch actuated when
truck switched on (for CanDis (o) or
the display unit (2-inch display) (o),
event message E-1914 appears)
Do not actuate the collision safety switch
"Slow travel" button actuated when
truck switched on (for CanDis (o) or
the display unit (2-inch display) (o),
event message E-1901 appears)
Do not actuate the button
Switch in mast implausible
(for CanDis (o) or on the display unit
(2-inch display) (o), event message
E-2124 appears)
– Lowering and travelling up to 1.5 km/h
possible
– Park the truck securely, see page 70
– Contact the manufacturer's customer
service department
Temperature sensor in hydraulic unit
overheated (for CanDis (o) or the
display unit (2-inch display) (o), event
message E-2406 appears)
– Lowering and travel possible
– Allow the hydraulic system to cool
down, see page 85
98
04.19 en-GB
To Next Page
Loading...
