Use as an elevated work table
The raised load handler can be used as an elevated work table when the truck is
switched off, see page 94.
4.8.2 Lowering the load handler
Requirements
– Prepare the truck for operation, see page 68.
Procedure
• Press the "Lower load handler" button (58) until you reach the desired lift height.
Z
The lowering speed can be infinitely adjusted via the travel of the button (approx.
8 mm).
Short switch stroke = slow lower
Long switch stroke = fast lower
The load handler is lowered.
4.8.3 Raising the wheel arms
Requirements
– Prepare the truck for operation, see page 68.
Procedure
• Press the “wheel arm raise” button (66) until you reach the desired wheel arm lift.
The wheel arms are raised.
4.8.4 Lowering the wheel arms
Requirements
– Prepare the truck for operation, see page 68.
Procedure
• Press the “wheel arm lower” button (65) until you reach the desired wheel arm lift.
The wheel arms are lowered.
84
04.19 en-GB
To Next Page
Loading...
Need help?
General
