Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detail summarySize of the test packet in bytes.Packet Size
detail summaryTheoretical frame rate in packets-per-second.Theoretical rate
(pps)
detail summaryPercentage of throughput for the test iteration.Percentage
throughput
detail summaryNumber of transmitted packets.Tx Packets
detail summaryNumber of received packets.Rx Packets
detail summaryPercentage of dropped frames for the specified packet sizeFrame Loss rate
percent
Sample Output
show services rpm rfc2544-benchmarking test-id detail (Throughput Test on ACX Series Routers )
user@host> show services rpm rfc2544-benchmarking test-id 19 detail
Test information :
Test id: 19, Test name: test1, Test type: Throughput
Test mode: Initiate-and-Terminate
Test packet size: 64 1280
Test state: RFC2544_TEST_STATE_COMPLETED
Test start time: 2005-07-29 10:25:00 UTC
Test finish time: 2005-07-29 10:26:02 UTC
Counters last cleared: Never
Test-profile Configuration:
Test-profile name: prof_tput
Test packet size: 64 1280
Therotical max bandwidth : 993000 kbps
Test Configuration:
Test mode: Initiate-and-Terminate
Duration in seconds: 20
Test family: INET
Routing Instance Name: default
Inet family Configuration:
Egress Interface : ge-0/1/1.0
Source ipv4 address: 192.0.2.1
Destination ipv4 address: 192.0.2.2
Source udp port: 2020
Destination udp port: 3030
Rfc2544 throughput test information :
Initial test load percentage : 100.00 %
Test iteration mode : Binary
Test iteration step percent : 50.00 %
Therotical max bandwidth : 993000 kbps
3169Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
