root> configure
5. Add a password to the root administration user account.
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
6. (Optional) Configure the name of the router. If the name includes spaces, enclose the
name in quotation marks (“ ”).
[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the router management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
NOTE: The management ports, em0 (C0) and em1 (C1), are found on the
FRU end of the ACX5048 router.
9. (Optional) Configure the static routes to remote prefixes with access to the
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
10. Enable Telnet service.
[edit]
root@# set system services telnet
11. Commit the configuration to activate it on the router.
[edit]
root@# commit
Safety Warnings
WARNING: This is a summary of safety warnings. For a complete list of
warnings, including translations, see the ACX5000 router documentation at
http://www.juniper.net/techpubs/.
WARNING: Failure to observe these safety warnings can result in personal
injury or death.
Copyright © 2015, Juniper Networks, Inc.10
ACX5048 Universal Access Routers Quick Start
To Next Page
Loading...
