Chapter 9 Barcode Scanner 91
General Screen
The General screen has the following functions:
Scan Time – Adjust the scan time, which is the duration of
time before the scanner times out. This is adjustable from
0.5 to 9.9 seconds, with 2 seconds as the default.
Enable or disable Aiming Crosshairs.
Enable or disable Decoding Illumination (red light).
Illumination Brightness – For better barcode performance,
we recommended that you leave illumination brightness
at the maximum value of 10.
Pick List Mode – Enable this mode if barcodes are close
together. The scanner only decodes barcodes aligned
directly under the center of the aiming crosshairs.
Disable this mode if only one barcode is viewable. When
disabled, the aiming crosshairs do not have to line up
directly on the barcode in order for the scanner to read
it. Just aim the scanner in the general area where the
barcode is located. This can be helpful in situations where
it might be difcult to precisely aim the scanner, such as
in locations with bright sunlight.
Consecutive Read Level – Select how many successful
consecutive reads the barcode must get before being
decoded.
To Next Page
Loading...
