Chapter 4 Bluetooth Wireless Communication 51
Note: If you are unsure whether or not the device requires
a passcode and if one has already been assigned to the
device, see the user documentation that came with the
device.
5. You can adjust the Bluetooth settings as needed.
Serial Device (COM) Control Panel
To set up a Bluetooth COM port, follow these steps:
1. Select COM Port, GPS, RFID from the Bluetooth dialog
box. The following Bluetooth COM conguration screen
is shown. Select Discover Devices.
2. After the handheld searches, a list of discovered devices
is shown. Select the device you want to connect to from
the list and tap Connect. A COM port is automatically
assigned for the device. You can change it to another
COM port if desired.
3. The Allegro 2 automatically tries to discover the PIN. You
might be required to enter a PIN.
You should now be connected to the COM device.
To Next Page
Loading...
