Juniper E Series

Monitoring Packet Mirroring ! 191
Chapter 6: Packet Mirroring
! Example 2
host1#show radius dynamic-request statistics
RADIUS Request Statistics
-------------------------
Statistic 10.10.3.4
----------------------------- -------
UDP Port 1700
Disconnect Requests 0
Disconnect Accepts 0
Disconnect Rejects 0
Disconnect No Session ID 0
Disconnect Bad Authenticators 0
Disconnect Packets Dropped 0
CoA Requests 0
CoA Accepts 0
CoA Rejects 0
CoA No Session ID 0
CoA Bad Authenticators 0
CoA Packets Dropped 0
No Secret 0
Unknown Request 0
Invalid Addresses Received :0
show secure policy-list
! Use to display information about secure policy lists, which are used for packet
mirroring.
! This command and the output are visible only to authorized users—the
mirror-enable command must be enabled prior to using this command.
! Use the name keyword to display information for a specific secure policy list.
! Field descriptions
! Policy—Type (IP or L2TP) and name of the policy list
! Administrative state—Status of administrative state, enable or disable; set
to enable when the policy list is created
! Reference count—Number of attachments to interfaces or profiles
! Classifier control list—Name of the classifier control list, which is always *
! Mirror analyzer-ip-address—IP address of analyzer device
! Analyzer-virtual-router—Analyzer interface virtual router
! Analyzer-udp-port—UDP port used to communicate with analyzer device
! Mirror-id—Unique identifier of the mirrored session
! Session-id—Unique identifier of the user session
! Referenced by interface(s)—List of interfaces to which the policy is
attached; indicates whether the attachment is at secure input or secure
output of interface
! Referenced by profile(s)—Not currently supported: always null
! Statistics—Not currently supported: always disabled