Juniper EX3200

Connecting EX3200 and EX4200 to AC power
To connect power to an AC-powered switch:
1. Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends of the wire clip into the holes in
the bracket on each side of the AC appliance inlet.
2. Insert the coupler end of the power cord into the AC appliance inlet.
3. Push the power cord into the slot in the adjustment nut of the power cord retainer clip. Turn the nut until it is snug
against the base of the coupler and the slot in the nut is turned 90° from the top of the switch.
4. If the AC power source outlet has a power switch, set it to the OFF (0) position.
5. Insert the power cord plug into the power source outlet.
6. If the AC power source outlet has a power switch, set it to the ON (|) position.
7. Repeat these steps for each AC power supply.
5