Juniper EX9200 Series

primary (external-a | external-b);
secondary (external-a | external-b);
signal-type (e1 | t1);
switching-mode (non-revertive | revertive);
transmitter-enable;
validation-interval seconds;
y-cable-line-termination;
}
synchronization { # for MX80 and MX240 routers
clock-mode (auto-select | free-run);
esmc-transmit {
interfaces (all | interface-name);
}
hold-interval {
configuration-change seconds;
restart seconds;
switchover seconds;
}
network-option (option-1 | option-2);
quality-mode-enable;
selection-mode (configured-quality|received-quality);
source {
(external-a | external-b) {
priority number;
quality-level (prc | prs |sec | smc | ssu-a | ssu-b | st2 | st3 | st3e | st4 | stu | tnc);
request (force-switch | lockout);
}
interfaces interface-name {
priority number;
quality-level (prc | prs |sec | smc | ssu-a | ssu-b | st2 | st3 | st3e | st4 | stu | tnc);
request (force-switch | lockout);
wait-to-restore minutes;
}
}
switchover-mode (revertive | non-revertive);
}
synchronization { # for ACX Series routers
clock-mode (auto-select | free-run);
esmc-transmit {
interfaces (all | interface-name);
}
hold-interval {
configuration-change seconds;
restart seconds;
switchover seconds;
}
network-option (option-1 | option-2);
quality-mode-enable;
selection-mode (configured-quality | received-quality);
source {
(bits | gps) {
priority number;
quality-level (prc | prs |sec | smc | ssu-a | ssu-b | st2 | st3 | st3e | st4 | stu | tnc);
request (force-switch | lockout);
}
interfaces interface-name {
25Copyright © 2013, Juniper Networks, Inc.
Chapter 4: Configuration Statements