Juniper EX9200 Series

... the lcc subhierarchy appears after the main [edit chassis] hierarchy ...
}
maximum-ecmp value;
memory-enhanced {
filter;
route;
vpn-label;
}
network-services (ethernet | enhanced-ethernet | ip | enhanced-ip);
(packet-scheduling | no-packet-scheduling);
pem {
minimum number;
}
policer-drop-probability-low;
ppp-subscriber-services (disable | enable);
redundancy {
cfeb slot (always | preferred);
failover {
on-disk-failure;
on-loss-of-keepalives;
}
feb {
redundancy-group group-name {
description description;
feb slot-number <backup | primary>;
no-auto-failover;
}
}
graceful-switchover;
keepalive-time seconds;
routing-engine slot-number (backup | disabled | master);
sfm slot-number (always | preferred);
ssb slot-number (always | preferred);
}
route-memory-enhanced;
route-localization {
inet (chassis);
inet6;
}
routing-engine {
bios {
no-auto-upgrade;
}
on-disk-failure disk-failure-action (halt | reboot);
}
sfm slot-number {
power off;
}
sib {
minimum number;
}
(source-route | no-source-route);
state [
cb-upgrade [on | off];
}
synchronization { # for M Series and T Series routers
Copyright © 2013, Juniper Networks, Inc.24
Class of Service Overview and Examples for EX9200 Switches