Juniper J-Series Administration Guide

Table 110: J-Web Ping MPLS Field Summary (continued)
Your ActionFunctionField
Instance to which this connection belongs
Type the name of the VPN to ping.Identifies the Layer 2 VPN to ping.Layer 2VPN
Name
Type the remote site identifier for the VPN.Specifies the remote site identifier of the Layer 2
VPN to ping.
Remote Site
Identifier
Type the source IP address—a valid address
configured on a Services Router interface.
Specifies the source address of the ping request
packet.
Source Address
Type the local site identifier for the VPN.Specifies the local site identifier of the Layer 2 VPN
to ping.
Local Site
Identifier
From the list, select the number of ping requests to
send. The default is 5 requests.
Specifies the number of ping requests to send.Count
Select the check box to display detailed output.Requests the display of extensive rather than brief
ping output.
Detailed Output
Locate LSP from interface name
From the list, select the Services Router interface
on which ping requests are sent. If you select any,
the ping requests are sent on all interfaces.
Specifies the interface on which the ping requests
are sent.
Interface
Type the source IP address—a valid address
configured on a Services Router interface.
Specifies the source address of the ping request
packet.
Source Address
From the list, select the number of ping requests to
send. The default is 5 requests.
Specifies the number of ping requests to send.Count
Select the check box to display detailed output.Requests the display of extensive rather than brief
ping output.
Detailed Output
Locate LSP from virtual circuit information
Type the IP address of the remote neighbor within
the virtual circuit.
Identifies the remote neighbor (PE router) within
the virtual circuit to ping.
Remote
Neighbor
Type the virtual circuit identifier for the Layer 2
circuit.
Specifies the virtual circuit identifier for the Layer 2
circuit to ping.
Circuit Identifier
Type the source IP address—a valid address
configured on a Services Router interface.
Specifies the source address of the ping request
packet.
Source Address
From the list, select the number of ping requests to
send.
Specifies the number of ping requests to send.Count
Select the check box to display detailed output.Requests the display of extensive rather than brief
ping output.
Detailed Output
Ping end point of LSP
Type either the LDP FEC prefix and length or the
RSVP LSP endpoint address for the LSP to ping.
Identifies the LSP endpoint to ping.VPN Prefix
Checking MPLS Connections from the J-Web Interface ■ 221
Chapter 12: Using Services Router Diagnostic Tools

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English