Juniper J-Series Administration Guide

Table 130: CLI monitor traffic Match Conditions (continued)
DescriptionMatch Condition
Matches all TCP packets.
tcp
Matches all UDP packets.
udp
Table 131: CLI monitor traffic Logical Operators
DescriptionLogical Operator
Logical NOT. If the first condition does not match, the next condition is
evaluated.
!
Logical AND. If the first condition matches, the next condition is evaluated.
If the first condition does not match, the next condition is skipped.
&&
Logical OR. If the first condition matches, the next condition is skipped. If
the first condition does not match, the next condition is evaluated.
||
Group operators to override default precedence order. Parentheses are special
characters, each of which must be preceded by a backslash (\).
()
Table 132: CLI monitor traffic Arithmetic, Binary, and Relational Operators
DescriptionOperator
Arithmetic Operator
Addition operator.
+
Subtraction operator.
–
Division operator.
/
Binary Operator
Bitwise AND.
&
Bitwise exclusive OR.
*
Bitwise inclusive OR.
|
Relational Operator
A match occurs if the first expression is less than or equal to the second.
<=
A match occurs if the first expression is greater than or equal to the second.
>=
A match occurs if the first expression is less than the second.
<
A match occurs if the first expression is greater than the second.
>
A match occurs if the first expression is equal to the second.
=
250 ■ Using CLI Diagnostic Commands
J-series™ Services Router Administration Guide

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English