1. On the console or other management device connected to the switch, enter the CLI operational mode
and issue the following command to shut down the switch software:
user@switch> request system halt
Wait until a message appears on the console confirming that the operating system has halted.
2. Disconnect power from the switch by performing one of the following: If the power source outlet has
a power switch, set it to the OFF (0) position. If the power source outlet does not have a power switch,
gently pull out the male end of the power cord connected to the power source outlet.
3. Remove the cables that connect the switch to all external devices. See “Disconnecting a Fiber-Optic
Cable” on page 139.
4. Remove all optical transceivers installed in the switch. See “Removing a Transceiver” on page 129.
Ensure that you have the following parts and tools available to pack the switch:
•
Phillips (+) screwdriver, number 2 (not provided)
•
The original switch packing material (cardboard box, accessory box and its contents, and foam padding)
•
ESD grounding strap
•
Antistatic bag
CAUTION: Do not pack the switch in anything except its original container or the switch
might be damaged in transit.
To pack the switch:
1. If the switch is installed in a rack or cabinet, have one person support the weight of the switch while
another person unscrews and removes the mounting screws.
2. Remove the switch from the rack or cabinet and place the switch on a flat, stable surface.
3. Use the screwdriver to remove the rack-mounting brackets from the switch chassis.
4. Place the switch in an antistatic bag.
5. Place the bottom portion of the packaging foam in the shipping carton.
6. Place the switch inside the cavity in the bottom packaging foam.
156
To Next Page
Loading...
Need help?
General
