NOTE: You must provide the appropriate mounting screws for mounting the switch on a rack or
a cabinet.
Registering Products—Mandatory for Validating SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
CAUTION: Register product serial numbers on the Juniper Networks website and update
the installation base data if there is any addition or change to the installation base or if
the installation base is moved. Juniper Networks will not be held accountable for not
meeting the hardware replacement service-level agreement for products that do not
have registered serial numbers or accurate installation base data.
Register your product(s) at https://tools.juniper.net/svcreg/SRegSerialNum.jsp.
Update your installation base at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp.
Mounting a QFX5120 Switch on Four Posts of a Rack or Cabinet
The four-post rack-mounting kit ships with the short front mounting brackets attached to the side mounting
rails. If you want to recess the switch in the rack, you must unscrew the short front mounting brackets
from the side mounting rails by using the Phillips (+) screwdriver, and then attach the long front mounting
brackets to the side mounting rails.
You can mount a QFX5120 switch on four posts of a 19-in. rack or a 19-in. cabinet by using a four-post
rack-mounting kit, which you must order separately. (The remainder of this topic uses rack to mean rack
or cabinet.)
93
To Next Page
Loading...
Need help?
General
