Juniper SRX340 Quick Start

You’ll also need:
•
Someone to help you do the installation
•
Rack mount screws appropriate for your rack
•
A number two Phillips (+) screwdriver
Rack It
Here’s how to install the SRX340 in a rack:
1. Review General Safety Guidelines and Warnings.
2. Wrap and fasten one end of the electrostatic discharge (ESD) grounding strap around your bare wrist, and connect the
other end to a site ESD point.
3. Attach the mounting brackets to the sides of the SRX340 using the eight mounting screws and the screwdriver.
Depending on how you’d like the SRX340 to sit in the rack, you can attach the mounting brackets to the front or center
mounting holes.
4. Lift the SRX340 and position it in the rack. Line up the bottom hole in each mounting bracket with a hole in each rack
rail, making sure that the SRX340 is level.
3

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB