SSG 500 M Series Hardware Installation and Configuration Guide
34 Default Device Settings
Default Device Settings
This section describes the default settings and operation of the SSG 500M Series
devices.
Table 8 describes the default interface-to-zone bindings on an SSG 500M Series
device.
Table 8: Default Interface-to-Zone Bindings
Note that the ethernet0/0 interface has the default IP address 192.168.1.1/24 and is
configured for management services. If you connect the ethernet0/0 port on the
device to a workstation, you can configure the device from a workstation in the
192.168.1.1/24 subnetwork using a management service such as Telnet. You can
change the default IP address on the ethernet0/0 interface to match the addresses
on your LAN. There are no other default IP addresses configured on other ports on
the device; you need to assign IP addresses to other interfaces.
Port Label Interface Zone
AUX serial0/0 Null
0/0 ethernet0/0 (default IP address is
192.168.1.1/24)
Trust
0/1 ethernet0/1 DMZ
0/2 ethernet0/2 Untrust
0/3 ethernet0/3 Null
PIM ports Untrust
EPIM ports Null
To Next Page
Loading...
Need help?
General
