Replacing an Air Filter 57
8. Insert one of the 512 MB SIMM DRAM modules into the slot from which you
just removed the 256 MB SIMM DRAM module. Exerting even pressure with
both thumbs upon the upper edge of the module, press the module downward
until the locking tabs click into position (Figure 28).
Figure 28: Installing a Memory Module
9. Locate the appropriate slot for the second 512 MB SIMM DRAM module. Repeat
step 8 to install the second memory module in the slot.
10. To replace the top panel on the chassis, set the front edge of the top panel into
the groove that runs along the top front edge of the chassis. Then lower the top
panel onto the chassis.
11. Use the phillips screwdriver to tighten the screws you removed earlier, securing
the top panel to the chassis.
Replacing an Air Filter
The front panel of the device includes a cooling air vent. To prevent foreign
particles from entering the device, the air vent includes a protective cover and, in
some cases, a filter.
If the temperature alarm continues to appear, we recommend inspecting the fan
filter. To remove a filter cover and replace a filter, use the procedures described in
this section.
To remove an air filter, perform the following steps:
1. Remove the filter cover by squeezing the plastic tabs on each side of the filter
cover.
NOTE: Depending on the working environment where the device is located, we
recommend changing the fan filter every six months. The fan filter SKU number is
SSG-500-FLTR.
To Next Page
Loading...
Need help?
General
