18
2 Preparation
Example:Proceed as follows to prepare one espresso using ground
coffee.
T Place a cup under the coffee spout.
T Open the powder chute cover.
‘Ground coffee’ / ‘Please add ground coffee’
T Place one level measuring spoon of ground coffee into the
filler funnel.
T Close the cover of the filler funnel.
T Press the
‘Espresso’ button.
Preparation starts.
‘Espresso’, the preset amount of water for
espresso flows into the cup.
Preparation stops automatically. Your JURA is once more
ready for use.
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
T Place a cup under the coffee spout.
T Press and hold the
‘Coffee’ button until ‘Enough coffee?
Press button’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
T Press any button except
‘Cancel’ as soon as there is sufficient
coffee in the cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
Your JURA is once more ready for use.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amounts for all single prod-
ucts in programming mode (see Chapter 4 ‘Permanent set-
tings in programming mode – Adjusting the product set-
tings’).
Permanently setting the
amount of water for the
cup size
To Next Page
Loading...
Need help?
General
Weight and Dimensions
