Just Motion Control 2DM556 - Default Chapter; Table of Contents

To Next Page

To Previous Page

Shenzhen Just Motion Control Electro-mechanics Co., Ltd 0755-26509689

- 3 -

Contents

1. Overview .......................................................................................... - 4 -

2. Features ........................................................................................... - 4 -

3. Ports Introduction .......................................................................... - 5 -

3.1 ALM signal output ports ........................................................ - 5 -

3.2 Control Signal Input Ports ..................................................... - 6 -

3.3 Power Interface Ports............................................................. - 7 -

4. Technological Index ........................................................................ - 8 -

5. Connections to Control Signal ....................................................... - 9 -

5.1 Connections to Common Anode ............................................ - 9 -

5.2 Connections to Common Cathode ....................................... - 10 -

5.3 Connections to Differential Signal ...................................... - 11 -

5.4 Connections to 232 Serial Communication Interface .......... - 12 -

5.5 Sequence Chart of Control Signals ...................................... - 12 -

6. DIP Switch Setting ........................................................................ - 13 -

6.1 Activate Edge Setting .......................................................... - 13 -

6.2 Running Direction Setting ................................................... - 14 -

6.3 Micro steps Setting .............................................................. - 14 -

7. Faults alarm and LED flicker frequency .................................... - 15 -

8. Appearance and Installation Dimensions ................................... - 17 -

9. Typical Connection ....................................................................... - 17 -

10. Parameter Setting ....................................................................... - 19 -

11. Processing Methods to Common Problems and Faults ........... - 24 -

11.1 Power on power light off ................................................... - 24 -

11.2 Power on red alarm light on............................................... - 24 -

11.3 After input pulse signal but the motor not running ............ - 24 -