Just Motion Control 2DM556 - Processing Methods to Common Problems and Faults; Power on Power Light Off; Power on Red Alarm Light On; After Input Pulse Signal but the Motor Not Running

Shenzhen Just Motion Control Electro-mechanics Co., Ltd 0755-26509689
- 24 -
(P20)
2DM556 gets the resistance through user sets.
Result of
position memory
(P21)
This parameter is set to control the smoothness of
Display the result of position memory
Time of enable
position memory
(P22)
This parameter is set of the time when enable the
position memory. The time is mean the space of
time to stop plus input.
11. Processing Methods to Common Problems and
Faults
11.1 Power on power light off
 No power input, please check the power supply circuit. The voltage
is too low.
11.2 Power on red alarm light on
 Please check the motor is connected with the drive.
 The stepper digital drive is over voltage or under voltage. Please
lower or increase the input voltage.
11.4 After input pulse signal but the motor not running
 Please check the input pulse signal wires are connected in reliable
way.
 Please make sure the input pulse mode is corresponding with the real
input mode.
 The Driver is disabled.