JVC BM-H2000PN User Manual

Z-\
12
A set of picture settings can be programmed in memory for
quick recall when necessary.
Recall/release of memory mode
Press the MEMORY MODE switch to recali a set of picture settings ee
programmed in memory. me Sera
Pressing the switch locks the functions of the front-panel PHASE, aca cine io aclah nea
: : appears on screen for approx. 2
CHROMA, BRIGHT, CONTRAST controls, and remote-control picture adjust- seconds ta indicate the function
ments not to be operated. cannot be operated.
Press again to release memory mode.
Setting programming of the picture being monitored — _ = nore’
The settings of the picture being monitored can be programmed in
memory. @ Programmed picture settings are kept
in memory after the power is turned
off.
Settings programmable in memory mode:
| @ Settings of the CONTRAST, BRIGHT, CHROMA and PHASE snnurcle on the
front panel
@ On-screen menu function settings (except RGB/COMPO(SDI))
| ° Rgmnote-cgntral ples aciusinent acing
‘MEMORY MODE >
Are you sure ?
2. Press the MENU button.
3. Press the & or ¥ button to select MEMORY MODE.
Then press the ENTER button,
4.@ Press the ENTER button to programme.
@ Press the < or P button to cancel, |
1 Check the MEMORY MODE switch is off |
=
S No maiter what video signal is input,
all items appear on screen. However,
depending on ihe type of input video
Revision of memory mode
Programmed picture settings can be revised if necessary.
1. signal, some funstions might not
Press the MEMORY MODE switch to activate memory mode. operate even if their sottings ‘aie
2. Press the MENU button to all up display ("Jon sereen. made.
(MEMORY MODE REVISE>
»PICTURE ADJUSTMENT
ASPECT RATIO :4-3
FILTER SELECT :COMB
PEAKING FREQ. :2.6MHZ
PEAKING LEVEL :0dB
AFC “NORMAL
COLOR TEMP. 26500
NTSC SETUP :0
COMPO. LEVEL :SMPTE
ENTERE ‘a
H
3. Press the & or ¥ button to select a function to be revised.
Press the ENTER button after selecting PICTURE ADJUSTMENT to call up
display [2). | | .
~ After making alll Sotngs on screen, press the MENU button to make display [1]
appear.
A. Press the < or button to change the set level.
Adjustable CONTRAST, BRIGHT, CHROMA or PHASE range depends on each
set level previously Stored | ir) memory. MAX appears to indicate maxirrium level
that cannot be increased. MIN appears to indicate minimum level that cannot be
decreased.
@Variable setting range _
“ADJUST-
MENT
SMPTE BETA | BE TATE. :
5. With display [1] on screen, press the MENU button to make display [3] appear.
@Press the ENTER button to programme. a a
@Press the < or ® button to cancel.
- ——
(MEMORY MODE REVISE?
>» CONTRAST :0
BRIGHT
Gooscs
elf the ENTER button is pressed after
a function ather than PICTURE
ADJUSTMENT
screen display ch
ling one. To select another tunétion:
after making a change in function,
press the MENU button to restore
display [7 Oo |
“MEMORY MODE REVISE >
Are you sure 7
“Yes” then ENTE
"No" then | orh}
13

JVC BM-H2000PN Specifications

General

Brand	JVC
Model	BM-H2000PN
Category	Monitor
Language	English