JVC CL-S500 Series User Manual

- 11 -
Recommended separation distances between
portable and mobile RF communications equipment and the model CL-S500
The model CL-S50 0 is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the model CL-S500 can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the model CL-S500 as recommended below,
according to the maximum output power of the communications equipment.
Immunity to proximity elds from following RF wireless communication equipment has been
conrmed:
Test
frequency
(MHz)
Bandwidth
a)
(MHz)
Service
a)
Modulation
b)
Maximum
power
(W)
Minimum
separation
distance
(m)
IEC/EN
60601
test level
(V/m)
Compliance
level
(V/m)
385 380–390 TETRA 400
Pulse
modulation
b)
1.8 0.3 27 27
450 430–470
GMRS 460,
FRS 460
FM
±5 kHz
deviation
1 kHz sine
2 0.3 28 28
710
704–787
LTE Band
13, 17
Pulse
modulation
b)
217 Hz
0.2 0.3 9 9745
780
810
800–960
GSM
800/900,
TETRA 800,
iDEN 820
CDMA 850,
LTE Band 5
Pulse
modulation
b)
18 Hz
2 0.3 28 28871
930
1720
1700–1990
GSM 1800;
CDMA
1900;
GSM 1900;
DECT;
LTE Band 1,
3, 4, 25;
UMTS
Pulse
modulation
b)
217 Hz
2 0.3 28 281845
1970
2450 2400–2570
Bluetooth,
WLAN,
802.11 b/g/
n,
RFID 2450,
LTE Band 7
Pulse
modulation
b)
217 Hz
2 0.3 28 28
5240
5100–5800
WLAN
802.11 a/n
Pulse
modulation
b)
217 Hz
0.2 0.3 9 95500
5785
a): For some services, only the uplink frequencies are included.
b): The carrier shall be modulated using a 50 % duty cycle square wave signal.

JVC CL-S500 Series Specifications

General

Brand	JVC
Model	CL-S500 Series
Category	Monitor
Language	English