o
Setting the camera to the pan cradle.
0
For how to connect the pan cradle and the camera, refer to the instruction
manual of the pan cradle for further details.
1
Set the camera to the pan cradle.
.
0
For how to connect the pan cradle and the camera, refer to the
instruction manual of the pan cradle for further details.
2
Set the power of the pan cradle to “ON”.
.
3
Wait until the pan cradle stops the rotation.
.
0
When the power is turned ON, pan cradle moves to the left/right to
adjust the position.
o
Operations from the smartphone application
0
Connect the camera and the smartphone via DIRECT MONITORING or
INDOOR MONITORING/OUTDOOR MONITORING.
“Image Monitoring via Direct Connection (DIRECT MONITORING)”
(A p. 132)
“Image Monitoring via an Access Point at Home (INDOOR MONITORING)”
(A p. 135)
“Image Monitoring via the Internet (OUTDOOR MONITORING)”
(A p. 140)
1
Start “Everio sync. 2”.
.
0
Start the application after confirming that the smartphone is
connected to this camera.
2
Tap the connection method.
.
3
Tap EF to perform the panning operation.
Using Wi-Fi (GZ-EX355/GZ-EX310)
151
To Next Page
Loading...
Need help?
General