_Owl_r Zoonl Lever
,Recording
Start/Stop Bulton
GripAdjustment
_ Separate the Velcro strip.
P_lss your right hand through the loop and grasp the
grip.
Adjust so that your thumb and fingers can easily
operate the Recording Start/Stop Button and Power
Zoom Lever. Refasten the Velcro strip.
• o
1 v
I®,1
Setto "CAMERA"
("AUTO" or "PRO,"),
1 \
VJewfJnder AcJjustmenl
Set tile Power Switch to "( AMERA" ("AUT(-)" or
"PRO.").
Adjust the viewfinder manually for best viewability.
Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
ShoulderStrapAttachment
the illustration, thread the strap through the
then fold it back and thread it through the
Jclde _. Repeat the procedure to attach the other
end of the strap to the other eyelet _), malting sure
the strap is not twisted.
Adjust as shown in the illustration _).
TripodMountin9
U lign the screw and camera direction stud on tile
tripod with the camera's mounting socket and stud
hole. Then tighten the screw.
CAUTION:
When using a tripod, be sure to open and extend
its legsfully to stabilize the camcorder. To
prevent damage to the unit caused by falling
over, do not use a small-sized tripod.
To Next Page
Loading...
