If, after following the steps in the chart below, the
problem still exists, please consult your nearest
JVC dealer.
The camcorder is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from
functioning properly. In such cases, first
disconnect its power supply unit (battery pack,
AC Adapter etc.) and wait a few minutes; and
then re-connect it and proceed as usual from
the beginning.
Power
TROUBLESHOOTINGEN 35
• Effects and "DIS" functions that cannot be used
together are selected at the same time.
_Re-read the sections covering Effects and "DIS".
( pg. 22, 23, 31)
• 32X optical zoom is selected.
_Set "ZOOM" to "64X" or "800X". ( pg. 23)
VideoPlayback
• , o " ,, ", • Your TV has AV input terminals, but is not set to
its VIDEO mode.
• The power is not connected properly.
-")Connect the AC Adapter securely. ( pg. 13)
• The battery pack is not attached firmly.
-")Detach the battery pack once again and re-attach
it firmly.( pg. 12)
• The battery is dead.
_Replace the dead battery with a fully charged
one. (: pg. 12)
VideoRecording
• The tape's erase protection tab is set to "SAVE".
_Set the tape's erase protection tab to "REC".
( pg. 16)
• "TAPE END" appears.
_Replace with new cassette. ( pg. 16)
• The cassette holder cover is open.
_Close the cassette holder cover.
• This is not a malfunction.
• This is not a malfunction.
• "DATE/TIME" is set to "OFF".
_Set "DATE/TIME" to "ON". ( pg. 22, 24)
_Set the TV to the mode or channel appropriate for
video playback.( pg. 21)
• The cassette holder cover is open.
_Close the cassette holder cover. ( pg. 16)
_Clean the video heads with an optional cleaning
cassette.(pg.40)
Advancedfeatures
• Focus is set to the Manual mode.
_Set Focus to the Auto mode. ( pg. 27)
• The lens is dirty or covered with condensation.
_Clean the lens and check the focus again.
( pg. 38)
• The16:9 Wide mode ([_ 16:9 indicator) is
selected.
_Disengage the 16:9 ([_[] 16:9 indicator) Wide
mode. (: pg. 22, 26)
To Next Page
Loading...
