• The viewfinder is pulled out and "PRIORITY" is
set to "FINDER".
TROUBLESHOOTINGEN 37
_Push the viewfinder back in or set "PRIORITY" to
"LCD'L ( pg. 18, 22, 24)
• The LCD monitor's brightness setting is too dark.
_Adjust the brightness of the LCD monitor.
( pg. 15)
If the monitor is tilted upward 180 degrees, open
the monitor fully. (: pg. 18)
Appears if a tape is not loaded when the
Recording Start/Stop Button or SNAPSHOT
Button is pressed while the Power Switch is set
to "REC".
Iq.,1".,i=!I=1i_I=]
Appears when the tape ends during recording or
playback.
-1:ii il;l i dil hN :1
|;li=4il'lii_il4_'iil'lilili|l_lll'_tliiI¢li-! • Appears when the date/time is not set.
• A malfunction of some kind has occurred. In this ( "pg. 14)
case the camcorder's functions become i The built-in clock battery has run out and the
unusable, previously set date/time has been erased.
-.I. pg.37. Consult your nearest JVC dealer for
replacement.
WarningIndications
I _ 1_lle#.,l"J
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
Displays the battery remaining power.
Remaining power level
High Exhausted
As the battery power comes close to nil the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
• Appears if a tape is loaded. ( pg. 16)
• Blinks when no tape is loaded. ( pg. 16)
Appears when pictures recorded in the HDV
format are detected. The pictures in the HDV
format cannot be played back with this
camcorder.
The error indications (01,02 or 06) show what
type of malfunction has occurred.When an error =c
• • -'" ." -' • -"• • L -' : indication appears, the camcorder turns off
Appears when the erase protection tab is set to automatically. Remove the power supply
"SAVE" while the Power Switch is set to "REC". (battery, etc.) and wait a few minutes for the
( "pg. 13) indication to clear. When it does, you can
resume using the camcorder. If the indication
x ' ' remains, consult your nearest JVC dealer.
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
( " pg. 40)
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
The error indications (03 or 04) show what type
of malfunction has occurred. When an error
indication appears, the camcorder turns off
automatically. Eject the cassette once and re-
insert it, then check if the indication clears.
When it does, you can resume using the
camcorder. If the indication remains, consult
your nearest JVC dealer.
To Next Page
Loading...
