When [Max & Min]/[Max]/[Min] is selected
A
The cursors appear according to the setting
when the button is pressed.
Green and yellow frames appear, and the
brightness levels of these areas are displayed.
.
(Yellow)
Cursor
(Green)
Cursor
Brightness Indication
B
Hold down the button in the state in A, the
positions of the brightest (Max) and darkest
(Min) areas in the screen are automatically
detected with regard to the changes of the
object, and the brightness level of these areas
are displayed.
.
(Min: Yellow)
Cursor
(Max: Green)
Cursor
Brightness Indication
C
Pressing the button in the state in B stops the
automatic position detection. The frames are
fixed at the stopped positions and the
brightness levels are displayed.
D
By pressing the button, the cursors and
brightness indication disappear.
.
When [Manual] is selected
A
The brightness of the cursor position is
displayed when the button is pressed.
.
Cursor (Green)
Brightness
Indication
B
By pressing the button, the cursors and
brightness indication disappear.
.
C
Hold down
the button in the state in A or B, the
cursor blinks in green.
Move the cursor with the cross-shaped button
(JKHI) to specify the position to display the
brightness.
When you decide on the position, press the Set
button (R) to confirm.
.
(Blinks in green)
Cursor
Brightness Indication
D
Frames are fixed at the stopped positions and
the brightness is displayed.
Memo :
0
When moving the cursor position, [Shutter]
/[AE
Level] control is disabled.
0
When
the
brightness is 0 % in the entire screen,
the frame is fixed in the center.
0
If the cursor is outside the “4:3” range, changing
[Main Menu] B [System] B [Record Set] B
[Record Format] B [SD Aspect] from “16:9” to
“4:3” restores the cursor to the default position.
(A
P119 [ SD Aspect ] )
73
Shooting
To Next Page
Loading...
Need help?
General
