If you want to record to an SD card, the
following three operations need to be
performed.
Compatible SD cards:
Panaeonic,TOSHNBA, pqi (still image only)
and SanDisk. 128 MB to 4 GB.
• If other media are used, they may fail to
record data correctly, or they may lose data
that had already been recorded.
• For video recording, use a high-speed SD
card (at least 10 MB/s).
® MultiMediaCards are not supported.
@ Insert SD card
an
Preparation:
Set the power/mode switch to OFF.
] Open the SD card cover,
Bottom of the
Camera
® Insert and remove the SD card only while
the power is turned off. Otherwise, data on
the card may be corrupted.
• Do not touch the terminal on the reverse
side of the label.
O Change the recording medium I
The camera is programmed to record on the
built-in hard disk when it is shipped from the
factory. You can change the recording medium
to SD card.
Set [REC MEDIA FOR VIDEO] and [REC
MEDIA FOR IMAGE] to [SD]. (_:_ pg. 47,
48)
O Format an SD card when using it for
the first time
This will also ensure stable speeds and
operation when accessing the SD card.
Select [EXECUTE] in [FORMAT SD
CARD] to format the card, (_ pg, 50)
2 Firmly insert the card with its clipped
edge first.
Clipped Edge
3 Close the SD card cover.
[] To remove an SD card
Push the SD card once.
After the card comes out a little, pull it out.
15
To Next Page
Loading...
