Changing the Menu Settings (Continued)
OFF: Disables the function.
[ON]: Activates the function.
[OFF]: Disables the function.
ON: Activates the function.
• The interval between recording still images is approx. 0.3
seconds.
• Continuous shooting may not work well depending on the
recording medium.
® The continuous shooting speed will drop if this function is
used repeatedly.
[OFF] / 2SEC / 10SEC
[HDD] / SD
Adjust the brightness of the display moving the set lever
to < / >, then press down.
OFF: Disables the function.
[ON]: Activates the function.
To turn the unit on when the drop detection worked, set
the power/mode switch to OFF, and to ON again.
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is accidentally
dropped.
OFF:The camera does not receive the signal from the
remote control.
[ON]: Enables operation with the remote control.
OFF: Disables the function.
[ON]: Activates the function.
® The demonstration only works when the DC cord is
connected, not with the battery.
• If an SD card is in the camera, demonstration will not take
place even if this mode is set to [ON].
OFF: Turns off the operation sound.
[MELODY]:The melody sounds when any operation is
performed.
48
To Next Page
Loading...
