JVC HR-XVS20E - Editing (DVD Deck); Digital Audio Dubbing

EN
63
EDITING (DVD DECK)
Digital Audio
Dubbing
You can dub selected audio from the DVD or Audio CD disc to a
MD etc.
However, it is not possible to dub the copy-protected disc.
Example: Dubbing to a MD
A
Make connections.
Connect the optical cable between the unit and the
digital audio device.
B
Place a disc and load a MD.
For the DVD deck
A
Press
x
on the DVD deck to open the disc tray.
B
Place the disc in the disc tray.
C
Press
x
on the DVD deck to close the disc tray.
For the digital audio device
Insert a MD.
C
Prepare the DVD deck for dubbing.
A
Press DVD and select the audio to be dubbed.
B
Search for the point where you want to start dubbing
by pressing
4
,
5
or
3
then press
8
.
C
Press
3
a little, then press
4
to start playback.
D
Press
9
to pause playback a little before the start
point.
D
Prepare the audio device for dubbing.
Select the input mode.
E
Start dubbing.
A
Press
4
to start playback on the DVD deck.
B
Start recording on the audio device.
F
End dubbing.
Press
8
on the audio device. Then press
8
to stop
playback on the DVD deck.
NOTE:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
●
Turn on the TV and select the video channel (or AV
mode).
●
Slide the TV/S-VHS/DVD switch to the right.
Rear of unit
Note for connection:
Remove the connector cover
from the unit and remove the
protection cap from the
cable.
Digital audio device
(MD deck etc.)
Optical cable
(not provided)
DIGITAL AUDIO OUT
Player
Recorder