EN
77
Display Settings
* The default setting is
bold
in the table below.
System Settings
* The default setting is
bold
in the table below.
Playback discs
Output
STREAM/PCM DOLBY DIGITAL/PCM PCM ONLY
DVD VIDEO with
48/44.1 kHz, 16/20/24 bit
linear PCM
48/44.1 kHz, 16/20/24 bit linear PCM
DVD VIDEO with
96/88.2 kHz linear PCM
No output
DVD VIDEO with DTS DTS bitstream 48 kHz, 16 bit stereo linear PCM
DVD VIDEO with Dolby
Digital
Dolby Digital bitstream
48 kHz, 16 bit stereo linear
PCM
Audio CD/Video CD 44.1 kHz, 16 bit stereo linear PCM
Audio CD with DTS DTS bitstream
NOTES:
●
The unit is not equipped with the DTS decoding function.
●
When you play back a DVD VIDEO or Audio CD disc with DTS, use a DTS decoder to get correct signals from your speakers.
Never use the unit’s analog output connectors, which output incorrect signals that may damage your speakers.
●
If you connect the analog outputs and digital outputs simultaneously, be sure to select the source of the amplifier correctly, or
set the level control of the amplifier connected to the analog outputs to minimum.
8
SCREEN SAVER
ON
OFF
The TV screen may be burned out if a static picture is displayed for a
long time. When this function is set to “ON”, the unit automatically
activates the screen saver function if a static picture, such as an on-
screen display or menu is displayed for over 5 minutes.
NOTE:
This function is not available for Audio CDs and MP3 discs.
8
ON SCREEN GUIDE
ON
OFF
When this function is set to “ON”, the unit can display “on-screen
guide” icons or characters which shows the conditions of the unit or
disc.
8
RESUME
ON
OFF
When this function is set to “ON”, you can use the resume function.
(
墌
pg. 39)
ON
: You can start playback from the resume point if it is
memorized.
OFF
: You cannot use the resume function.
NOTE:
This function is not available for Audio CDs and MP3 discs.
To Next Page
Loading...
Need help?
General
