Preparing the remote controller
Before using the remote controller:
. Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
Remote sensor
. Do
not
expose the remote sensor to strong
light (direct sunlight or artificial lighting).
lnstallinu the battery
When the controllable range or effectiveness of
the remote controller decreases, replace the
battery.
1. Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball-point
pen or a similar tool.
2) Remove the battery holder.
2. Place the battery.
Siide the battery into the holder with the +
side facing upwards so that the battery is
fixed in the holder.
3. Return the battery holder.
Insert again the battery
holder by
until you hear a clicking
sound.
pushing it
WARNING:
9 Store the battery in a pluce where children
cannot reu(,h.
Jf
a child uccidentaily swullows the battery,
cunsdt a
ductor immediately.
l
Do not recharge, short, disassemble, or heat the
battery ur dispose of it in a$re.
Doing any of these things may cuuse the batteg\
to give off heat, crack, or start ajre.
l
Do not leave the buttery with other
metallic
materials.
Doing thus may cause the battery to give oj
he&, crack, or start ujire.
l
When throwing away or suving the battery,
wrup it in tupe and insulate; otherwise, the
buttery
muy
start
to
give .off heat,
crack,
or ,start
a fire.
9 Ilo not
poke the
buttery
with tweezers or similar
tOOiS.
Doing this may cause the battery to give off
heat, truck, or start u
jire.
DO NOT leave the remote controLler in a place
a lung time. Otherwise, it may be damaged.
~
0
Lithium coin
9
battery (product
number: CFQO25)
6