TROUBLESHOOTING %i/:
What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
Causes
l
Sound cannot be heard
from the speakers.
The volume level is set to the
minimum level.
Check the cords and connections.
Connections are incorrect.
Press the reset button on the
panel holder after detaching the
control panel. (The clock setting
and preset stations stored in
memory are erased.)
(See page 2”)
l
This unit does not work
at all.
The built-in microcomputer may
have functioned incorrectly due
to noise, etc.
l
“Panel Connect Error”
appears on the display.
The control panel is not attach
correctly and firmly.
Remove the control panel, wipe
the connectors, then attach it
again. (See page 47.)
Signals are too weak. Store stations manually.
1
l
SSM (Strong-station
Sequential Memory)
automatic preset does
not work.
antenna
firmly. The antenna is not connected
firmly.
Static noise while
listening to the radio.
Connect the
Disc is inserted upside down. Insert the disc correctly.
l
Disc cannot be played
back.
l
CD-R/CD-RW cannot be
played back.
. Tracks on the CD-R/
CD-RW cannot be
skipped.
l
Insert a finalized CD-R/CD-RW.
. Finalize the CD-R/CD-RW
with the component which
you used for recording.
CD-R/CD-RW is not finalized.
l
Disc cannot be ejected. DISC is locked. Unlock the disc. (See page 19.)
l
Disc cannot be
recognised (“No Disc,”
“Loading Error,” or “Eject
Error” flashes on the
display,)
The CD player may function
incorrectly.
While holding CD/CD-CH (LINE)
(for KD-LH3150) or CD/CD-CH
(for KD-LH31 OO), press SEL for
more than 2 seconds to eject
the disc.
. Disc sound
interrupted.
is
sometimes
You are driving on rough roads. Stop playback
rough roads.
while driving on
Disc is scratched.
Change the disc.
Connections are incorrect. Check the cords and connections.
l
“No Disc”
display.
flashes on the No disc in the loading slot.
Insert a disc into the loading
slot.
Insert the disc correctly. Disc is inserted incorrectly.
To Next Page
Loading...
Need help?
General
