TV: MAINTENANCE
Handling discs
When playing a CD-F? or CD-RW
This unit has been designed to reproduce CDs,
CD-F& (Recordable), CD-RWs (Rewntable), and
CD Texts.
l
This unit is also compatible with MP3 discs.
How to handle discs
When removing a disc
from its case, press down
the center holder of the case
and lift the disc out, holding
Et by the edges.
Center holder
l
Always hold the disc by the edges. Do not
touch its recording surface.
When storing a disc into its case, gently insert
the disc around the center holder (with the
printed surface facing up).
l
Make sure to store discs into the cases after
use.
To keep discs clean
A dirty disc may not play correctly.
If a disc does become dirty, wipe it
with a soft cloth in a straight line
from center to edge.
To play new discs
New discs may have some rough
spots around the inner and outer
edges. If such a disc is used, this
unit may reject the disc.
To remove these rough spots, rub
the edges with a pencil or ball-point pen, etc.
Moisture condensation
Moisture may condense on the lens inside the
CD player in the following cases:
. After starting the heater in the car.
. If it becomes very humid inside the car.
Should this occur, the CD player may
malfunction. In this case, eject the disc and leave
the unit turned on for a few hours until the
moisture evaporates.
Before playing back CD-F& or CD-RWs, read
their instructions or cautions carefully.
l
Use only “finalized” CD-Rs or CD-RWs.
l
Some CD-Rs or CD-RWs may not play back on
this unit
because
of their disc characteristics,
and for the following reasons:
- Discs are dirty or scratched.
- Moisture condensation on the lens inside the
unit.
- The pickup lens inside the unit is dirty.
. CD-RWs
may
require a longer readout time
since the reflectance of CD-RWs is lower than
that of regular CDs.
l
CD-Rs or CD-RWs are susceptible to high
temperatures or high humidity, so do not leave
them inside your car.
. Do not use following CD-Rs or CD-RWs:
- Discs with stickers, labels, or protective seal
stuck to the surface.
- Discs on which labels can be directly printed
by an ink jet printer.
Using these discs under high temperatures or
high humidity may cause malfunctions or
damage to discs. For example,
- Stickers or labels may shrink and warp a
disc.
- Stickers or labels may peel off so discs
cannot be ejected.
- Print on discs may get sticky.
Read instructions or cautions about labels and
printable discs carefully.
CAUTKINS:
l
Llu not insert 8 cm {3-3/16’7 discs {single CDs}
into the iuading slot. (Such discs cannot be
ejected.)
9 IJo not insert any disc of unu.~uul ~shupe-like a
heurt orflower; othetwise, it will cause a
mal@nction.
. Do not expose disc&y to direct suntight or uny
heat MNU-~~ or pluce them in u pluce subject to
high temperature and humidity. Do nut leave
them in a cam
l
Du no1 u.$e uq solvent vor exumple,
convention& record cleaner spruy, thinnec
benzine, etc.) to clean discs.
60
To Next Page
Loading...
Need help?
General
