33
ENGLISH
Continued on the next page
Other external component
operations
You can connect an external component to
the LINE IN plugs on the rear or to the CD
changer jack on the rear using the Line Input
Adapter—KS-U57 (not supplied) or AUX Input
Adapter—KS-U58 (not supplied).
• For connection, see Installation/Connection
Manual (separate volume).
For listening to the SD card/USB memory, see
pages 14 – 17; For iPod, or D.player, see pages
27 – 29.
~
LINE-IN : For selecting the external
component connected to the
LINE IN plugs.
EXT-IN : For selecting the external
component connected to the
CD changer jack.
If “EXT-IN” does not appear, see page 25
and select the external input (“Ext In”).
Ÿ Turn on the connected component
and start playing the source.
! Adjust the volume.
⁄ Adjust the sound as you want. (See
pages 18 – 22.)
Maintenance
How to clean the connectors
Frequent detachment will deteriorate the
connectors.
To minimize this possibility, periodically wipe
the connectors with a cotton swab or cloth
moistened with alcohol, being careful not to
damage the connectors.
Moisture condensation
Moisture may condense on the lens inside the
CD player in the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the CD player may
malfunction. In this case, eject the disc and
leave the unit turned on for a few hours until
the moisture evaporates.
How to handle discs
When removing a disc from
its case, press down the center
holder of the case and lift the
disc out, holding it by the edges.
• Always hold the disc by the
edges. Do not touch its recording surface.
When storing a disc into its case, gently insert
the disc around the center holder (with the
printed surface facing up).
• Make sure to store discs into the cases after
use.
Center holder
Connector
EN24-35_SH1000E_003A_f.indd 33EN24-35_SH1000E_003A_f.indd 33 1/16/06 4:43:27 PM1/16/06 4:43:27 PM
To Next Page
Loading...
Need help?
General
