JVC KD-SV3000 - Removing the VCD;CD Mechanism Board; Removing the CD Mechanism Assembly

(No.49837)1-7
2.1.7 Removing the VCD/CD mechanism board
(See Fig. 7)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover, rear bracket and main board.
(1) Remove the five screws H attaching the VCD/CD mecha-
nism board.
(2) Disconnect the card wire from the connector CN601 on the
VCD/CD mechanism board.
(3) Move the VCD/CD mechanism board in the direction of the
arrow to release it from the joint f.
Fig.7
2.1.8 Removing the CD mechanism assembly
(See Fig. 8)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover, rear bracket, main board and VCD/CD mechanism
board.
(1) Remove the three screws J attaching the top chassis.
(2) Take out the CD mechanism assembly.
Fig.8
H
H
VCD/CD mechanism board
CN601
Card wire
Top chassis
Joint f
J
J
CD mechanism assembly
Top chassis