28
ENGLISH
Turning on/off the key-touch tone
You can deactivate the key-touch tone if you do not want to make it beep when you press a
button. When shipped from the factory, the key-touch tone is activated.
• ON: Activates the key-touch tone.
• OFF: Deactivates the key-touch tone.
1. Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “BEEP” with
¢ or 4.
3. Select the desired mode with the control dial.
The key-touch tone alternates between on and off.
Selecting the scroll mode
You can select the scroll mode for the name display and disc information if it consists of more
than 8 characters. When shipped from the factory, Auto Scroll mode is set to “ONCE.”
• ONCE: Scrolls only once
• AUTO: Repeats the scroll (5-second intervals in between)
• OFF: Cancels Auto Scroll
1. Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “SCROLL” with
¢ or 4.
3. Select the desired mode with the control dial.
The scroll mode changes as follows:
Note:
Even if the scroll mode is set to “OFF,” you can scroll the display by pressing DISP for more than 1
second.
Selecting the subwoofer cutoff frequency
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for
your subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to
“MID.”
• MID: Frequencies higher than 80 Hz are cut off to the subwoofer.
• HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.
• LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.
1. Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “CUTOFF F” with
¢ or 4.
3. Select the desired mode with the control dial.
The subwoofer cutoff frequency changes as follows:
ON
OFF
MID
HIGH
LOW
AUTOONCE
OFF
EN21-29.KD-SX950[J]/F 99.12.13, 1:15 PM28
To Next Page
Loading...
Need help?
General
