JVC KS-BTA200 - Bluetooth Audio Operations; Selecting Bluetooth Audio Source; Bluetooth Audio Playback Controls

29
• Before you use a Bluetooth device on your receiver, connect a Bluetooth device. See “Bluetooth
Connection” on page 12.
• When sound is stopped or interrupted during the use of a Bluetooth device, try the following
remedies.
• Turn Off, then turn On the power to the receiver.
• (When sound is not yet restored,) Connect the device again. See “Connecting/Disconnecting the
device“ on page 17.
• For details of the menu operations, refer to the instruction manual supplied with your receiver.
• Indications on the display (monitor) and button names vary among the receivers.
ex. SOURCE: SRC 7: 7 / BACK
Bluetooth Audio: Bluetooth AUDIO, BT-AUDIO
Bluetooth Audio Operations
Selecting a source
Before you operate the Bluetooth audio device, change
the source to “Bluetooth Audio.”
for Type A
You can select “Bluetooth Audio” as the source.
Press SRC repeatedly to select
“Bluetooth Audio.”
for Type B/Type C/Type D
You can select “Bluetooth Audio” as the source.
Press SOURCE repeatedly to select
“Bluetooth Audio.”
Playback operations
for Type A/Type B
3: Start playback
6: Start playback/Pause
¢: Forward skip
4: Reverse skip
7: Stop
for Type C
1: Start playback
3: Stop
¢: Forward skip
4: Reverse skip
for Type D
5: Start playback
¢: Forward skip
4: Reverse skip
Bluetooth Phone/Bluetooth Audio
KS-BTA200_book.indb 29KS-BTA200_book.indb 29 07.2.23 11:39:37 AM07.2.23 11:39:37 AM