JVC KW-V640BT - Installing the Unit

42 ENGLISH
Installation and ConnectionInstallation and Connection
Parts list for installation
Note: This parts list does not include all the package
contents.
¥ Wiring harness (× 1)
ø Extension parking cable, 2 m (× 1)
π Flat head screws, M5 × 8 mm (× 6)
[ Round head screws, M5 x 8 mm (× 6)
“ Steering wheel remote input cable (× 1)
Only for KW-V640BTM Region 2/KW-M540BT
Australian/New Zealand models/KW-M540BTM
] Microphone, 3 m (× 1)
Installation procedure
1 Remove the key from the ignition and
disconnect the
· battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5 Connect the wiring harness to the unit.
6 Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7 Reconnect the · battery.
8 Configure <Initial Settings>. (Page4)
Installing the unit
Installing the unit using the mounting
bracket removed from the car
Car bracket
π / [
π / [
Note: Select the appropriate screws (supplied) for the
mounting bracket.
Installing in Toyota cars
Install onto the car bracket using the supplied screws
([). Use the mounting holes (A or B) that fit the car
bracket.
Side view
ENKW-V2018TCM.indb42ENKW-V2018TCM.indb42 2018/01/1615:062018/01/1615:06