JVC KW-XC770

20
ENGLISH
Adjusting the sound
You can adjust the sound characteristics to your preference.
1
Select (“SEL”) the item you want to adjust.
Indication To do: Range
BAS Adjust the bass –6 (min.) — +6 (max.)
(Bass)
TRE Adjust the treble –6 (min.) — +6 (max.)
(Treble)
FAD Adjust the front and rear speaker R6 (rear only) — F6 (front only)
(Fader)* balance
BAL Adjust the left and right speaker L6 (left only) — R6 (right only)
(Balance) balance
LOUD Turn on or off the loudness function** ON — OFF
(Loudness)
VOL Adjust the volume 00 (min.) — 50 (max.)
(Volume)
Notes:
* If you are using a two-speaker system, set the fader level to “00.”
** The loudness function can boost low and high frequencies to produce a well-balanced sound at
low volume levels. When the loudness function is “ON,” the LOUD indicator changes from
to on the display.
2
Adjust the level.
Note:
Normally the control dial works for volume adjustment. So you do
not have to select “VOL” to adjust the volume level.
SEL
SEL
1
2
LOUD indicator
EN19-21.KW-XC770[J]/1 99.11.24, 3:27 PM20